Check And Correct The Adjustment Of The Headlamps - AP82.10-P-8260J
Model 213, 238
Halogen headlamp, shown On Model 213
Static LED headlamp, shown On Model 213
Dynamic LED headlamp, shown On Model 213
Shown On Model 213
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear buttoned-up and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| General information on checking/correcting headlamp adjustment | AH82.10-P-1000-01A | ||
| Check | |||
| 1 | Check low beam setting; adjust if necessary | Halogen headlamp ECE version | AP82.10-P-8263O |
| Halogen headlamp SAE version | AP82.10-P-8263NA | ||
| Static LED headlamps, ECE version | AP82.10-P-8263KA | ||
| Static LED headlamps, SAE version | AP82.10-P-8263CA | ||
| Dynamic LED headlamps, ECE version | AP82.10-P-8263MA | ||
| Dynamic LED headlamps, SAE version Before the low beams are checked and adjusted, all operation steps listed in the linked description must be performed carefully. Otherwise it cannot be guaranteed that the headlamps concerned are correctly set, which can then jeopardize the road safety of the vehicle. |
AP82.10-P-8263LA | ||
| 2 | Switch on high beam | On vehicle with active high beams assistant ↓ Have a second person actuate the headlamp flasher in order to activate the high beams. |
|
| 3 | Check setting of high beam | The headlamp adjuster (01) must be positioned in front of the left high beam (E1e1) or left front adaptive high beam (E1e24). Carry out the same procedure for the right side. If the high beam setting is not OK. ↓ Rectify the problem subject to a separate repair order. |
AP82.10-P-8260-02I |
| 4 | Reset switch positions to input condition |