Remove/Install Side Supplemental Restraint System (SRS) Pressure Sensor - AR91.60-P-0760GQ
Model 166
Model 292
Shown on model 166
| Risk of injury during testing and repair operations related to pyrotechnical components | Do not expose pyrotechnical component parts to temperatures above 100°C or 212°F. Disconnect current supply when working on such component parts. | AS91.00-Z-0008-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Disconnect battery ground line | AR54.10-P-0003GZ | |
| 2.1 | Remove door lining from left or right front door | For removing left front door pressure sensor (B48/7) or right front door pressure sensor (B48/8). Remove/install front door lining Model 166 with code Z04 (Light armoring) with code Z05 (B5 armoring on special protection version) |
AR72.10-P-1000GQS |
| Model 166 except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version) Model 292 |
AR72.10-P-1000GQ | ||
| 2.2 | Remove door lining from left or right rear door | For removing left rear door pressure sensor (B48/9) or right rear door pressure sensor (B48/10). Model 166 with code Z04 (Light armoring) Model 166 with code Z05 (B5 armoring on special protection version) |
AR72.12-P-1010GQS |
| Model 166 except code Z04 (Light armoring) except code Z05 (B5 armoring on special protection version) Model 292 |
AR72.12-P-1010GQ | ||
| 3 | Disconnect electrical connector (1) from respective pressure sensor | ||
| 4 | Push retaining clips downwards (arrow) and remove the respective pressure sensor | ||
| 5 | Install in the reverse order |