Remove/Install 360 Degree Camera Control Unit - AR54.65-P-0012LWG
Model 253
with code 501 (360° camera)
MODIFICATION NOTES
| 27.08.2015 | "Calibrate all cameras of the 360° camera system using the diagnostic system" added. | Operation step 10 |
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Notes on HANDS-FREE ACCESS | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and remove transmitter key | ||
| 2 | Remove left side load compartment paneling | Model 253 (except 253.992/993) with code 501 (360° camera) |
AR68.30-P-1180LWG |
| Model 253.992/993 with code 501 (360° camera) |
AR68.30-P-1180RFW | ||
| 3 | Slacken off bolts (1) far enough to enable the bracket (2) to be removed | ||
| 4 | Remove bracket (2) and turn to one side | ||
| 5 | Unscrew nut (3) | ||
| 6 | Remove 360° camera control unit (N148) from bracket (2) | ||
| 7 | Release and disconnect electrical connections (4) | ||
| 8 | Install in the reverse order | ||
| 9 | Commission 360° camera control unit (N148) using diagnostic system | If the 360° camera control unit (N148) was replaced. | |
| AD00.00-P-2000-04B | |||
| 10 | Calibrate all the cameras for the 360° camera system using the diagnostic system | If the 360° camera control unit (N148) was replaced. | |
| AD00.00-P-2000-04B |