Retrofit Illuminated Door Sill Molding - AZ82.20-P-0001LWG

Model 253 (except 253.364/964)

except code U25 (Illuminated door sill panels with "Mercedes-Benz" lettering)

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove
1	Move driver seat and front passenger seat towards rear
2	Disconnect battery ground line
			AR54.10-P-0003LW
3	Remove left and right front inner door sills
4	Remove cover below left of instrument panel
			AR68.10-P-1500LW
5	Remove cover below right dashboard
			AR68.10-P-1520LW
6	Remove side paneling of instrument panel at left
7	Remove left and right front door sills	The door sills are no longer required. Mounting wedge	Fig 1
8	Remove front left floor covering
			AR68.20-P-2050LW
9	Remove front right floor covering
			AR68.20-P-2070LW
	Install
10	Retrofit wiring harness for illuminated door sill moldings		AZ82.20-P-0001-04LWG
		Right front footwell ground point (CAN)	*BA00.19-P-1019-01E
11	Retrofit left front illuminated door sill molding (E17/47) and right front illuminated door sill molding (E17/48)		AZ82.20-P-0001-01LWG
12	Retrofit illuminated door sill molding control unit		AZ82.20-P-0001-05LWG
		Self-adhesive felt strip 40 X 2 mm	*BR00.45-Z-1074-01A
		Binder Duotec® Pilz in Pilz Klett - with adhesive 32	*BR00.45-Z-1084-02A
13	Install remaining parts
	Update Vehicle Documentation (VeDoc)
14	Attach a note "Illuminated door sill moldings retrofitted as per AZ82.20-P-0001LWG" under field organization texts for DG 68 and DG 82
	Check
15	Cover light sensor in windshield and perform function check on left front illuminated door sill molding (E17/47) and right front illuminated door sill molding (E17/48)	The left front illuminated door sill molding (E17/47) is switched on by opening the front left door and the right front illuminated door sill molding (E17/48) is switched on by opening the front right door. The left front illuminated door sill molding (E17/47) or right front illuminated door sill molding (E17/48) switches off automatically approx. 5 min after opening a door or after automatic shutoff of the ambient illumination.

GROUND POINTS

Number	Designation			Model 253 (except 253.99)	Model 253.99
BA00.19-P-1019-01E	Right front footwell ground point (CAN)	W15/8	Nm	10	10

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

REPAIR MATERIALS

Number	Designation	Order number
BR00.45-Z-1074-01A	Self-adhesive felt strip 40 X 2 mm	A 001 983 23 10
BR00.45-Z-1084-02A	Binder Duotec® Pilz in Pilz Klett - with adhesive 32	Klettband Technik Schultz UG

PARTS ORDERING NOTE

Part no.	Designation	Quantity
KG 98	Scope of supply of illuminated door sill moldings	1
KG 98	Electric line bridge	1