Carry Out Distance And Comparison Measurements On Front And Rear Axles - AR40.30-P-0402LW

WARNING: This page is about a different car, the 2023 Mercedes-Benz GLC300, 2022 Mercedes-Benz GLC300, 2021 Mercedes-Benz GLC300, 2020 Mercedes-Benz GLC350e, and 2020 Mercedes-Benz GLC300. However, it is still accessible from the selected car via links, so may be relevant.

Model 205

Model 213

Model 238

Model 253

Model 293

	Risk of death caused by vehicle slipping or toppling off of the lifting platform.	Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Risk of death caused by vehicle slipping or toppling off during lifting	Only lift vehicle at the lift support points specified by the vehicle manufacturer.	AS00.00-Z-0032-01A
	Check
1	Perform initial accident diagnosis	Model 238	AR60.00-P-1105LWO
		Model 253, 293	AR60.00-P-1105LWX
		Model 205	AR60.00-P-1105LW
		Model 213	AR60.00-P-1105LWE
2	Conduct distance and comparative measurement on front axle and rear axle 000 588 01 23 00 Body straightening system	These measurements determine whether it is necessary to replace chassis components or repair the body on the straightening bench. If visible damage is found (e.g. crack formation, deformation) on the front axle carrier or rear axle carrier these parts must be replaced. A distance and comparative measurement on the front axle and rear axle using the "beam trammel" measurement method is not permissible.	WS60.00-P-0023K
3	Repair vehicle	Where damage has been detected.
4	Perform wheel alignment check	If the vehicle has been repaired. Model 238	AR40.20-P-0200LWO
		Model 205, 213, 253, 293	AR40.20-P-0200LW