Remove/Install Flywheel/Drive Plate - AR03.30-P-8001MFI
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2023 Mercedes-Benz CLA45 AMG, 2023 Mercedes-Benz CLA35 AMG, 2023 Mercedes-Benz CLA250, 2022 Mercedes-Benz CLA45 AMG, and 2022 Mercedes-Benz CLA35 AMG. However, it is still accessible from the selected car via links, so may be relevant.
Engine 260 in model 118, 177, 247 with transmission 724.1
Shown on model 177
Fig 1: Flywheel/Drive Plate Components Location - Engine 260 In Model 118 With Transmission 724.1 (Shown On Model 177)
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on avoiding damage through contamination and foreign objects | AH00.00-P-5000-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| Remove | |||
| 1 | Remove transmission. | AR27.10-P-0009MFA | |
| 2 | Install retaining lock for crankshaft/starter ring gear. | AR03.30-P-5000MFC | |
| 3 | Loosen screws (1 - 8). | Otherwise, damage to the crankshaft will occur. |
|
| 4 | Remove screws (1 - 8) and remove flywheel/drive plate (9). | ||
| 5 | Check rear radial shaft sealing ring for damage. | If there are problems, ↓ Replace rear radial shaft sealing ring. |
AR03.20-P-3064MFC |
| Install | |||
| 6 | Position flywheel/drive plate (9) on crankshaft. | ||
| 7 | Tighten screws (1 - 8) slightly by hand and tighten in numerical sequence as per the illustration. | *BA03.30-P-1003-01S | |
| 8 | Remove retaining lock for crankshaft/starter ring gear. | AR03.30-P-5000MFC | |
| 9 | Install transmission. | AR27.10-P-0009MFA |
FLYWHEEL, DRIVE PLATE, VIBRATION DAMPER, STARTER RING GEAR
| Number | Designation | Engine 260 | ||
|---|---|---|---|---|
| BA03.30-P-1003-01S | Bolt, two-mass flywheel/drive plate to crankshaft | Stage 1 | Nm | 45 |
| Stage 2 | ∠° | 90 | ||