Remove/Install Stabilizer Bar On Front Axle - AR32.20-P-0300V

MODEL 171 

MODEL 172 with ENGINE 152, 271, 276, 651 

Fig 1: Stabilizer Bar On Front Axle Components Location - Model 172 With Engine 276 (Shown On Model 171.442)

Courtesy of MERCEDES-BENZ USA

Shown on model 171.442 

	Remove/install
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
		These parts must be replaced if there are any visible signs of damage (crack formation or deformation) to chassis parts.
1	Lower front axle		AR33.10-P-0101V
2	Remove the front wheels		AP40.10-P-4050V
3	Detach torsion bar link rods (78) from torsion bar (77)		*BA32.20-P-1002-02B
4	Detach linkage from left front level sensor to body	MODEL 171 with CODE (614) Bi-xenon headlamp units	*BA82.10-P-1002-01A
5	Release left front level sensor from torsion bar (77)	Model 172 with automatic headlamp range adjustment	*BA82.10-P-1008-01A
6	Release right front level sensor from torsion bar (77)	Model 172 with code (483) ADVANCED AGILITY package	*BA82.10-P-1008-01A
7	Remove bolts (5) and remove torsion bar (77)	Model 171: Remove torsion bar (77) to side. Model 172: Remove torsion bar (77) to rear.	*BA32.20-P-1007-02B
8	Install in the reverse order	: Tighten nuts and bolts of chassis components only when vehicle is in the ready-to-drive condition.
9	Perform wheel alignment check	Model 171	AR40.20-P-0200V
		Model 172	AR40.20-P-0200EW
10	Connect Star Diagnosis and adjust zero position of left front level sensor and right front level sensor		AD00.00-P-2000-04A