Remove/Install Rear Axle Track Rod - AR35.20-P-0109RQ
Model 190
except code 201 (Rear axle steering)
Model 197
Shown on model 197
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | AS00.00-Z-0002-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Notice | Notes on handling, transport and storage of composite brake disks | AH42.10-P-9406-12LF | |
| Notice | Notes on handling, transport and storage of ceramic brake disks | AH42.10-P-9406-13A | |
| Notice | Notes on threaded connections fastened using a tightening angle-based tightening process | AH00.00-P-0020-01A | |
| Notice | Notes on repairs to brake system | AH42.00-P-0003-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove/install | |||
| 1 | Switch off ignition and store transmitter key outside of transmitter range (min. 2 m). | ||
| 2 | Remove rear wheel and tire assembly. | AR40.10-P-1100RQ | |
| 3 | Pry tie rod (1) off wheel carrier (2). | ||
| *BA35.20-P-1001-04J | |||
| Fig 2 | |||
| Fig 3 | |||
except code 201 (Rear axle steering) |
Fig 5 | ||
| Thrust piece | |||
| Fig 4 | |||
| Thrust piece | |||
| 4 | Remove tie rod (1) from body. | Bolts and nuts for suspension components may only be tightened when in ready-to-drive condition. Otherwise, the suspension components may be damaged. |
|
While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the of the parts will be reduced. |
|||
| *BA35.20-P-1002-04J | |||
| 5 | Install in the reverse order. | ||
| Measure | |||
| 6 | Perform chassis alignment. | AR40.20-P-0200RQ |
TIE ROD
| Number | Designation | Model 190 | Model 197 | ||
|---|---|---|---|---|---|
| BA35.20-P-1001-04J | Self-locking nut, tie rod to wheel carrier | Stage 1 | Nm | 70 | 40 |
| Stage 2 | ∠° | 90 | 90 | ||
TIE ROD
| Number | Designation | Model 190 | Model 197 | ||
|---|---|---|---|---|---|
| BA35.20-P-1002-04J | Self-locking nut, tie rod to wheel carrier | Stage 1 | Nm | 50 | 50 |
| Stage 2 | ∠° | 90 | 90 | ||