Remove/Install Rear Floor Covering - AR68.20-P-4800GQ

MODEL 166.0 

	Remove/install
1	Remove front seats		AR91.10-P-1000GQ
2	Remove rear seat cushion	MODEL 166 60 % rear seat cushion MODEL 166 40 % rear seat cushion	AR91.12-P-1020GQ AR91.12-P-1020GQA
3	Remove rear seat backrest	60% rear seat 40% rear seat	AR91.12-P-1620GQ AR91.12-P-1620GQA
4	Remove door sill moldings		AR68.30-P-4100GQ
5	Detach electrical line from 115 V socket	MODEL 166.0 with CODE U80 (115 V socket) The 115V socket is located in the right rear footwell.
6	Pull out floor covering (1) below paneling (2) on B-pillar	: Ensure that floor covering (1) is routed correctly below paneling (2) on B-pillars. Long wedge Mounting wedge	Figure Figure
7	Pull floor covering (1) out below center console (4) toward rear	: Ensure that floor covering (1) is routed correctly below center console (4). Long wedge Mounting wedge	Figure Figure
8	Remove floor covering (1)	Ensure that floor covering (1) is routed correctly on frame floor. Otherwise the air ducting and electrical lines can be damaged. Helper required.
9	Install in the reverse order

Fig 1: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Long Wedge (115 589 03 59 00)

Courtesy of MERCEDES-BENZ USA