Remove/Install Rear Seat Backrest - AR91.12-P-1620GQA
MODEL 166.0
40% rear seat
| Remove/install | |||
| Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | AS91.00-Z-0001-01A | |
| Risk of injury . Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating range of the mechanism when moving components. | AS00.00-Z-0009-01A | |
| Notes on performing repair, body work and welding on vehicles with airbags and RTE units | AH91.00-P-0002-01M | ||
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | AH91.00-P-0004-01A | ||
| Assessment of airbag and belt tensioner units in accident vehicles | AH91.00-P-0006-01B | ||
| 1 | Disconnect battery ground line | MODEL 166.0 with CODE 298 (Rear sidebag with belt force limiter) 40% rear seat |
AR54.10-P-0003GZ |
| 2 | Fold up seat cushion | ||
| 3 | Remove bolt (1) | *BA91.12-P-1001-03F | |
| 4 | Remove anchoring lugs from trunk | *BA68.50-P-1002-03F | |
| 5 | Unclip panel under anchoring lugs | ||
| 6 | Place insulation mats concealed below to one side | ||
| 7 | Separate electrical connectors (2) | ||
| 8 | Remove bolt (3) | *BA91.12-P-1001-03F | |
| 9 | Remove rear seat backrest | ||
| 10 | Install in the reverse order |
CARGO RETAINERS
| Number | Designation | MODEL 166 | |
|---|---|---|---|
| BA68.50-P-1002-03F | Bolt, tie-down eye to body/trunk floor | Nm | 24 |
REAR SEATS
| Number | Designation | MODEL 166.0 | |
|---|---|---|---|
| BA91.12-P-1001-03F | Bolt, rear seat console to vehicle floor | Nm | 50 |