Remove/Install Front Bumper - AR88.20-P-2000XG
Model 463
as of model year 2019
Shown on model 463.260 without code C75 (stainless steel ram protection)
Fig 1: Front Bumper Components Location - Model 463 As Of Model Year 2019 (Shown On Model 463.260 Without Code C75)
Shown on model 463.260 without code C75 (stainless steel ram protection)
Shown on model 463.260 without code C75 (stainless steel ram protection)
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels. |
AS00.00-Z-0017-01A | |
| Information on preventing damage to electronic components due to electrostatic discharge | AH54.00-P-0001-01A | ||
| Remove/install | |||
| 1 | Raise vehicle using vehicle lift. | AR00.60-P-1006A | |
| 2 | Remove bullbar bumper. | Model 463 (except 463.276/277) as of model year 2019 with code C74 (Impact protection, painted black) Model 463 (except 463.276/277) as of model year 2019 with code C75 (Stainless steel brush guard) |
AR88.30-P-0025XG |
| Model 463.276/277 as of model year 2019 with code C74 (Impact protection, painted black) Model 463.276/277 as of model year 2019 with code C75 (Stainless steel brush guard) |
AR88.30-P-0025XGA | ||
| 3 | Unscrew screws (4) from the front bumper. | ||
| 4 | Remove expansion rivet (7) from the front bumper. | Fig 2 | |
| 5 | Lower the vehicle. | AR00.60-P-1006A | |
| 6 | Loosen the fender liner in the front fender (2) until the front bumper electrical connector (X26/38) and the screws (3) are accessible. | AR88.10-P-1300XG | |
| 7 | Disconnect the front bumper electrical connector (X26/38) from the right of the front bumper (1). | ||
| 8 | Remove screws (3) on left and right of front bumper (1). | ||
| 9 | Unlock the catch hook (5) from the front bumper (1) on the left and right. | ||
| 10 | Unlock the catch hook (6) on the front bumper (1). | ||
| 11 | Lower the sides of the front bumper (1) downwards and remove the front bumper (1) to the front. | ||
| 12 | Install in reverse order. |