Remove/Install Front Roller Sunblind For Panoramic Sliding Roof - AR77.21-S-0207E
Model 447.7/8, 448.8
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notice | Notes on self-locking nuts and bolts | AH00.00-P-0001-01KOA | |
| Notice | Notes on carrying out repair work in the vehicle interior | AH68.00-D-0001-01KOS | |
| Remove/install | |||
| 1 | Remove panoramic sliding roof | AR77.21-S-6923E | |
| 2 | Remove rear headliner | Model 447.7 with code V23 (Interior trim, premium version) except code ZH6 (Marco Polo ACTIVITY) Model 447.8 with code V23 (Interior trim, premium version) except code ZK7 (Equipment line MARCO POLO) Model 448.8 |
AR68.30-S-7608E |
| 3 | Move roller sun blind (1) on emergency actuation (2) of panoramic sliding roof roller sun blind drive unit (M11) toward rear to stop | ||
| 4 | Remove roller sun blind (1) from guide rail (3) | AR77.21-S-0201-01E | |
| Install roller sun blind (1) on guide rails (3) | AR77.21-S-0201-02E | ||
| 5 | Turn roller sun blind (1) and insert anti-twist lock (7) from bottom into right roller bearing (1.2) (arrow B) | If an anti-twist lock (7) is not available for removal. ↓ Use an approx. 10 cm long wire with a diameter of approx. 1.5 mm |
|
| 6 | Unscrew bolts (4, 8) and remove roller sun blind (1) together with retaining plate (9) | ||
| 7 | Unscrew bolts (10) on both sides of roller sun blind (1) and remove roller sun blind (1) from retaining plate (9) | ||
| 8 | Install in the reverse order | ||
| Check | |||
| 9 | Check roller sun blind (1) for proper function |