Check And Adjust Concentricity Of Drive Flange - AR35.30-P-4671GW

MODEL 463 

as of model year 2013/facelift 2012 

Courtesy of MERCEDES-BENZ USA

	Removing
1	Mark installation position of propeller shaft relative to drive flange (1)
2	Disconnect propeller shaft from drive flange (1)	Tie up propeller shaft at the side of the frame.
		Tool Kit	Fig 1
	Measure
3	Carry out concentricity measurement on the drive flange (1)		AR35.30-P-4671-02GW
		Total concentricity deviation of flange	*BE35.30-P-1004-01A
		Dial Indicator	Fig 3
		Indicator Holder	Fig 4
		Measuring Flange	Fig 2
		If there is damage present:
		↓
		Remove/install drive flange (1).	AR35.30-P-0472GW
		Mark position of drive flange (1). The concentricity is set through gradual displacement of the drive flange (1):
		↓
		Adjust concentricity of drive flange (1).	AR35.30-P-4671-01GW
		Tool Kit	Fig 1
		Retainer Wrench	Fig 5
		Puller	Fig 6
		Following each displacement of the drive flange (1) a renewed concentricity measurement must be made on the drive flange (1):
		↓
		Carry out concentricity measurement on the drive flange (1).	AR35.30-P-4671-02GW
		Measuring Flange	Fig 2
		Dial Indicator	Fig 3
		Indicator Holder	Fig 4
	Install
4	Fit propeller shaft to drive flange (1)	Note marking.
	Notes on self-locking nuts and bolts		AH00.00-N-0001-01A
		Bolt, propeller shaft to drive flange	*BA41.10-P-1003-01B
		Tool Kit	Fig 1

INSPECTION DATA OF REAR AXLE FINAL DRIVE

Number	Designation		Model 460, 461, 463
BE35.30-P-1004-01A	Total concentricity deviation of flange	mm	≤ 0, 07

PROPELLER SHAFT

Number	Designation		Model 463
BA41.10-P-1003-01B	Bolt, propeller shaft to drive flange	Nm	35

Fig 1: Identifying Tool Kit (000 589 10 99 00)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Measuring Flange (460 589 01 23 00)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Dial Indicator (001 589 53 21 00)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Dial Indicator Holder (363 589 02 21 00)

Courtesy of MERCEDES-BENZ USA

Fig 5: Identifying Retainer Wrench (460 589 01 31 00)

Courtesy of MERCEDES-BENZ USA

Fig 6: Identifying Puller (460 589 02 33 00)

Courtesy of MERCEDES-BENZ USA