Remove/install torsion bar on rear axle - AR32.20-P-0315LWI
MODEL 205.386/387/486/487
MODIFICATION NOTES
| 08.04.2016 | Bolt, torsion bar linkage to torsion bar | BA32.20-P-1001-04S |
Shown on removed rear axle
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Notes on handling, transport and storage of ceramic brake disks | Model 205.386/387/486/487 with code B07 (Ceramic brake system) | AH42.10-P-9406-13A | |
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| Notes on repair work on suspension components | AH00.00-P-0100-01A | ||
| Remove | |||
| 1 | Remove rear axle. | AR35.10-P-0010LW | |
| 2 | Remove both stabilizer bar linkage (2) from torsion bar (1) | ||
| 3 | Remove level sensors with brackets from rear axle carrier (3) and place to one side | If installed. | AR82.10-P-0005LW |
| 4 | Take off and remove torsion bar (1) from rear axle carrier (3) | ||
| Check | |||
| 5 | Check elastomer bearing (4) for damage and wear | If there are problems ↓ Replace torsion bar (1) |
|
| Clean | |||
| 6 | Clean the inside thread of the torsion bar (1) using a tap M10 | When reinstalling stabilizer bar (1). | |
| Install | |||
| 7 | Mount torsion bar (1) onto rear axle carrier (3) | *BA32.20-P-1002-04S | |
| 8 | Mount level sensors with brackets onto rear axle carrier (3) | If installed. | AR82.10-P-0005LW |
| 9 | Mount both stabilizer bars (2) onto torsion bar (1) | Thread locking agent, Loctite 243 (10 ml) |
*BR00.45-Z-1133-02A |
| *BA32.20-P-1001-04S | |||
| 10 | Install rear axle | AR35.10-P-0010LW |
REAR AXLE TORSION BAR
| Number | Designation | Model 205 except code 489 (AIRMATIC) | |
|---|---|---|---|
| BA32.20-P-1001-04S | Bolt, torsion bar linkage to torsion bar | Nm | 63 |
REAR AXLE TORSION BAR
| Number | Designation | Model 205 except code 489 (AIRMATIC) | |
|---|---|---|---|
| BA32.20-P-1002-04S | Nut, torsion bar to rear axle carrier | Nm | 80 |
REPAIR MATERIALS
| Number | Designation | Order number |
|---|---|---|
| BR00.45-Z-1133-02A | Thread locking agent, Loctite 243 (10 ml) | A 613 989 09 71 09 |