Remove paneling in trunk - AR68.30-P-4600LW
Model 205.0/1
Shown on MODEL 205.0 except CODE ME06 (Hybrid drive 50 KW variant (Including Plug-in))
Shown on MODEL 205.0 except CODE ME06 (Hybrid drive 50 KW variant (Including Plug-in))
| Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | AS00.00-Z-0011-01A | |
| Notes on sensor system for trunk lid opening/closing | AH80.61-P-0001-01A | ||
| Remove/install | |||
| 1 | Open luggage compartment lid | ||
| 2.1 | Remove retaining clips (2) and floor covering (1) | Model 205.0/1 except code ME06 (Hybrid drive 50-KW variant (incl. plug-in)) |
|
| Figure | |||
| 2.2 | Remove front section of load compartment floor | Model 205.0/1 with code ME06 (Hybrid drive 50-KW variant (incl. plug-in)) |
|
| AR68.20-P-4811LW | |||
| 3 | Remove rear center section paneling (3) | AR68.30-P-4785LW | |
| 4 | Remove tie-down eyes (7) | Model 205.0/1 with code 287 (Folding rear seat backrests) Model 205.0/1 with code 30P (Stowage Space package) |
|
| *BA68.50-P-1001-03I | |||
| 5 | Pull paneling (10) out of cover (4) and unclip cover (4) | Model 205.0/1 except code ME06 (Hybrid drive 50-KW variant (incl. plug-in)) |
|
| Figure | |||
| 6 | Remove cover (4) toward rear | Model 205.0/1 except code ME06 (Hybrid drive 50-KW variant (incl. plug-in)) |
|
| 7 | Remove left trunk paneling (5) and right trunk paneling (6) | AR68.30-P-4800LW | |
| 8 | Remove cover (10) | ||
| 9 | Install in the reverse order |
CARGO RETAINERS
| Number | Designation | Model 205 | |
|---|---|---|---|
| BA68.50-P-1001-03I | Screw/bolt for tie-down eye | Nm | 24 |