Remove/install media interface - AR82.60-P-1031CY

MODEL 204.9 as of model year 2013 with CODE 518 (Media interface) 

Fig 1: Identifying Media Interface Remove/Install Components (1 Of 4)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Media Interface Remove/Install Components (2 Of 4)

Courtesy of MERCEDES-BENZ USA

Fig 3: Identifying Media Interface Remove/Install Components (3 Of 4)

Courtesy of MERCEDES-BENZ USA

Fig 4: Identifying Media Interface Remove/Install Components (4 Of 4)

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Release center console (1) until it can be lifted		AR68.20-P-2000CW
2	Unclip Media Interface electrical connector (X18/67) and feed through downwards
3	Pull center console (1) toward rear and out of the instrument panel, then lift
4	Expose electrical line (12) from center console (1)	To do so, release expansion clip (3) and clamp (4) on inside at center console (1) Mount expansion clip (3) and clamp (4) again
5	Remove cover (5) below instrument panel		AR68.10-P-1520CW
6	Remove glove box lid (6)		AR68.10-P-1200CY
7	Release floor covering (7)
8	Disconnect electrical connectors (8, 9) at media interface control unit (N125/1)
9	Remove radio until electrical connector (10) is accessible		AR82.60-P-7502CY
10	Disconnect electrical connector (10)
11	Cut cable tie (11)	Replace cable tie (11)
12	Expose electrical wiring harness (12) and remove
13	Install in the reverse order
14	Read out and erase the fault memory using Star Diagnosis
			AD00.00-P-2000-04A