Remove/Install Glove Compartment Lid - AR68.10-P-1200CY

MODEL 204.9 

Fig 1: Identifying Glove Compartment Lid Remove/Install Components (1 Of 2)

Courtesy of MERCEDES-BENZ USA

Fig 2: Identifying Glove Compartment Lid Remove/Install Components (2 Of 2)

Courtesy of MERCEDES-BENZ USA

	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
	Remove/install
1	Switch off ignition
2	Remove cover below right dashboard		AR68.10-P-1520CW
3	Remove right trim strip on dashboard	MODEL 204.9 up to model year 2013	AR68.10-P-1180CY
4	Remove side covering (1)	Mounting wedge	Figure
5	Remove AUX jack electrical connector (X39/45) from glove box (3)	Vehicles without code (518) Media Interface
			AR68.10-P-1400-01CW
6	Remove cover (5) from electrical media interface connector (X18/67)	Vehicles with code (518) Media Interface
7	Unclip media interface electrical connector (X18/67) from glove box (3) and move out of glove box (3) toward rear	Vehicles with code (518) Media Interface
8	Unlock retaining clip (9) for glove box vent hose
9	Remove bolts (2, 7, 8)
10	Remove bolts (10)	Rechargeable screwdriver, rechargeable drill
11	Disconnect electrical connector (11) from glove box lamp (E13/1)
12	Disconnect electrical connector 12) from glove box socket (X58/31)
13	Disconnect electrical connector and USB connector from communications module control unit (N112/2)	MODEL 204.9 with CODE B54 (COM module)
			AR82.85-P-0020CYA
14	Knock left and right hinge bolt (13) out of guide in glove box lid (6) and pull out of glove box lid (6)
15	Pull locking pin (14) on damper (15) through opening (16) in glove box lid (6)
16	Remove glove box lid (6) and damper (15) from glove box (3)	Observe installation position of damper (15).
17	Install in the reverse order
18	Connect STAR DIAGNOSIS and read fault memory	MODEL 204.9 with CODE B54 (COM module)
			AD00.00-P-2000-04A

Fig 3: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ USA