Remove/install antenna - AR82.70-P-8951V

MODEL 171.4 

Illustrated on removed rod antenna 

Fig 1: Identifying Antenna Components - Illustrated On Removed Rod Antenna

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		A
	Risk of injury  caused by fingers being jammed or pinched  when removing/ installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	When moving components, ensure that no body parts or limbs are within the operating range of moving parts.
1	Positioning trunk lid to assembly position		AR88.50-P-5000-01V
			Figure
2	Undo trunk lining at upper left side	To do this, remove clips at top left side of trunk lining and push left side of trunk lining in direction of center of trunk. Refer to: ↓
		Remove/install side paneling in trunk	AR68.30-P-4800V
3	Unscrew rod (1) of rod antenna (A28) from antenna pedestal (2)
4	Disconnect connector (3) from left antenna amplifier module (A2/64)
5	Unscrew nut (4) and remove antenna pedestal (2) with antenna line (5) from above	Counterhold antenna support (6) in trunk.
6	Remove antenna support (6)	Note installation position of antenna support (6).
7	Install in the reverse order

Fig 2: Identifying Support (170 589 04 63 00)

Courtesy of MERCEDES-BENZ USA