Preparations for distance and comparison measurements - AR40.30-P-0401T
WARNING: This page is about a different car, the 2009 Mercedes-Benz E550 and 2008 Mercedes-Benz E550. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 211, 219
Shows on model 211
Fig 1: Identifying Rear Engine Crossmember, Bores For Mount, Reference Point, Shims And Threaded Stud
| Removing | |||
| 1 | Align the vehicle | Measure the inclination across the door sills, e.g. using a spirit level |
|
| 2.1 | Detach lower engine compartment paneling | Vehicles with gasoline engine | |
| Model 211 | AR61.20-P-1105T | ||
| Model 219 | AR61.20-P-1105TX | ||
| 2.2 | Remove bottom section of soundproofing | Vehicles with diesel engine | |
| Model 211 | AR94.30-P-5300T | ||
| Model 219 | AR94.30-P-5300TX | ||
| 3 | Remove the left and right underfloor paneling upstream of the rear axle | Model 211 | AR61.30-P-1001T |
| Model 219 | AR61.30-P-1001TX | ||
| 4 | Screw in threaded bolt (07n) of |
||
| *170589006300 | |||
| 5 | AR40.30-P-0401-01T | ||
| 6 | |||
| *124589086300 | |||
| *124589011900 | |||
| *124589021900 | |||
| *168589076300 | |||
| Measure | |||
| 7 | Carry out distance and comparison measurements on front and rear axles | AR40.30-P-0402T | |
| Install | |||
| 8 | |||
| 9 | Screw in bolts of rear engine crossmember (63) | *BA22.10-P-1005-03A | |
| *BA22.10-P-1006-01S | |||
| *BA22.10-P-1003-01D | |||
| 10 | Install underfloor paneling | Model 211 | AR61.30-P-1001T |
| Model 219 | AR61.30-P-1001TX | ||
| 11.1 | Install lower engine compartment paneling | Vehicles with gasoline engine | |
| Model 211 | AR61.20-P-1105T | ||
| Model 219 | AR61.20-P-1105TX | ||
| 11.2 | Install bottom sections of soundproofing | Vehicles with diesel engine | |
| Model 211 | AR94.30-P-5300T | ||
| Model 219 | AR94.30-P-5300TX |
ENGINE SUSPENSION, ENGINE MOUNTS, ENGINE SUPPORTS
| Number | Designation | Engine 642 in model 219 | |
|---|---|---|---|
| BA22.10-P-1003-01D | Bolt/nut, rear engine crossmember to body | Nm | 40 |
ENGINE MOUNT, ENGINE SUPPORT (ENGINE SIDE)
| Number | Designation | Model 211 except 4MATIC | Model 211 with 4MATIC | |
|---|---|---|---|---|
| BA22.10-P-1005-03A | Rear engine support to body | Nm | 50 | 50 |
ENGINE SUSPENSION, ENGINE MOUNTS, ENGINE SUPPORTS
| Number | Designation | Engine 113 in model 219 | Engine 272, 273 in model 219 | |
|---|---|---|---|---|
| BA22.10-P-1006-01S | Bolt, rear engine crossmember to body | Nm | 50 | 50 |
ENGINE SUSPENSION, ENGINE MOUNTS, ENGINE SUPPORTS
| Number | Designation | Engine 156.983 in model 219 | |
|---|---|---|---|
| BA22.10-P-1006-01S | Bolt, rear engine crossmember to body | Nm | 40 |