Remove/install rear spring (MODEL 211 ONLY) - AR32.20-P-0230T
WARNING: This page is about a different car, the 2011 Mercedes-Benz C300, 2010 Mercedes-Benz C300, 2009 Mercedes-Benz C300, and 2008 Mercedes-Benz C300. However, it is still accessible from the selected car via links, so may be relevant.
MODEL 211.08 /09 except CODE (489) AIRmatic (semi-active air suspension)
| Remove/install | |||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Remove rear wheel | ||
| Remove/install wheels | AP40.10-P-4050Z | ||
| 2 | Remove spring control arm cover | ||
| 3 | Detach shock absorber from spring control arm | ||
| *BA32.25-P-1003-03A | |||
| Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; shield off hazard area if necessary. Inspect special tools for damage and proper operation (visual inspection). Wear protective gloves. |
AS00.00-Z-0001-01A | |
| 4 | Clamping rear spring | AR32.20-P-0200-06T | |
| Springs; general background information. | AH32.20-P-9404-01A | ||
| 5 | Install in the reverse order | ||
| 6 | Check headlamp setting and correct if necessary | ||
| Check and correct headlamp adjustment | AP82.10-P-8260CW |
REAR AXLE SHOCK ABSORBER
| Number | Designation | Model 211 steel suspension | |||
|---|---|---|---|---|---|
| BA32.25-P-1003-03A | Self-locking nut for attaching shock absorber to spring control arm | - | Stage 1 | Nm | - |
| Stage 2 | ∠° | - | |||
| M10 | Nm | 55 | |||