Remove/install cover of pedal assembly - AR29.10-P-0320V

MODELS 171.4 with TRANSMISSION 716.6, 722.9 

Fig 1: Identifying Pedal Assembly Cover Components

Courtesy of MERCEDES-BENZ USA

Shown on model 171 with transmission 716 

	Remove/Install
1	Turn key in ignition lock (electronic ignition switch control unit) to position "0"
2	Remove left cover below instrument panel		AR68.10-P-1500V
3.1	Remove clutch pedal switch (S40/3)	Vehicles with transmission 716	AR25.20-P-0095V
4	Unlock and remove front cover (1)	The front cover (1) is engaged at three points (arrows) in the rear cover (2). To unlock, lift up the notches (2a).
5	Unclip voltage distributor (CAN) (3) on the front cover (1) and take out the front cover (1)
6.1	Remove pedal assembly (4)	When removing the rear cover (2)
		Vehicles with transmission 716	AR29.10-P-0300V
		Vehicles with transmission 722	AR29.10-P-0300VA
7	Unlatch and remove rear cover (2) from the pedal assembly (4)	The rear cover (2) is engaged at four points in the pedal assembly (4). To unlock, open the catch webs (2b).
8	Install in the reverse order