Remove/install passenger-side outside mirror backup camera - AR54.65-P-0035GZ

MODEL 164, 251 with CODE (218) Backup camera with CODE (498) Japan version 

Shown on Japan version of model 164 (code 498, right-hand drive vehicle): 

Fig 1: Identifying Passenger-Side Outside Mirror Backup Camera Remove/Install Components

Courtesy of MERCEDES-BENZ USA

	Remove/install
	Notes on avoiding damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1	Remove front door lining	Separate additional electrical connector for passenger-side outside mirror backup camera (B84/6x1).
		Model 164	AR72.10-P-1000GZ
		Model 251	AR72.10-P-1000RT
2	Detach trim of outside mirror (1)	Work with care so that the mirror lens and passenger-side outside mirror backup camera (B84/6) are not damaged. Unclip passenger-side outside mirror backup camera (B84/6).
		Model 164	AR88.70-P-9040GZ
		Model 251	AR88.70-P-9040RT
3	Remove outside rearview mirror completely	Model 164	AR88.70-P-9000GZ
		Model 251	AR88.70-P-9000RT
4	Remove foam material (2)
5	Unscrew bolts (3), remove outside mirror (8) from cover (4) and pull through (5)
6	Detach clamping plate (6), remove rubber seal (7) from outside mirror (8)
8	Install in the reverse order
9	Calibration of passenger-side outside mirror backup camera (B84/6)	If only the passenger-side outside mirror backup camera (B84/6) has been removed, the steering angle sensor does not have to be calibrated.	AR54.65-P-0022GZ