Remove/install driver side instrument panel, bottom section - AR68.10-P-1505GZ

MODEL 164 

Shown on model 164.1 

Fig 1: Identifying Cover And Bolt - Shown On Model 164

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on model 164.1, cover below instrument panel removed for better illustration 

Fig 2: Identifying Bolts - Shown On Model 164.1, Cover Below Instrument Panel Removed For Better Illustration

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on model 164.1 

Fig 3: Identifying Bolts - Shown On Model 164.1

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Fig 4: Identifying Driver Side Instrument Panel Remove/Install Components Bottom Section

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

	Remove/install
1	Remove center console		AR68.20-P-2000GZ
2	Remove lower control panel control unit	Do not disconnect electrically	AR54.21-P-1263GZ
3	Remove instrument cluster		AR54.30-P-6015GZ
4	Remove left cover below instrument panel		AR68.10-P-1500GZ
5	Remove side air outlet		AR68.10-P-1100GZ
6	Unclip cover (1) (arrow A)	Installation:  Position cover (1) on door first.
		Mounting wedge	Figure
7	Unscrew bolts (2 to 8)	On model 164.8, bolts (6, 8) are replaced by nuts.
		Handymaster battery-powered drill/screwdriver	*WH58.30-Z-1007-20A
8	Lower instrument panel bottom section (13).
9	Unhinge Bowden cable (9)
10	Disconnect electrical connector (10) from rotary light switch (S1)
11	Disconnect electrical connector (11, 12) from EIS control unit (N73)
12	Remove instrument panel bottom section (13)
13	Install in the reverse order

Fig 5: Identifying Mounting Wedge (110 589 03 59 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.