Remove/install bracket for compressor - AR32.22-P-2009T

MODEL 211.0 /2 with CODE (489) AIRmatic (semi-active air suspension) 

MODEL 211.6 

Fig 1: Identifying Compressor Bracket Components

Fig 2: Identifying Bracket And AIRmatic Compressor Unit

	Remove/install
1	Remove AIRmatic compressor unit (A9/1)	Model 211.0/ 2 with Airmatic (semi-active air suspension) code 489	AR32.22-P-2001T
		Model 211.2 except Airmatic model 211.6	AR32.22-P-2001TA
2	Undo bolts (1a) and place valve unit (1) to one side.	Do not disconnect pressure lines and electrical connectors.
			*BA32.22-P-1011-03A
3	Remove left front lamp unit (E1)		AR82.10-P-4730TA
4	Remove bolts (2a)		*BA32.22-P-1012-03A
5	Apply liquid lubricant to bolts (3).	Lubricant	*BR00.45-Z-1002-06A
6	Slide bracket (2) of AIRmatic compressor unit (A9/1) backwards out of rubber mount (4) and remove
	Checking
7	Check rubber mount (4) of bracket (2)	Check rubber mount (4) for hardening and damage and replace if necessary.
8	Replace all stop buffer and attaching parts (A) on the AIRmatic compressor unit (A9/1)	If reusing the stop buffer and attaching parts (A) knocking and thumping noise may occur.	AR32.22-P-2011T
9	Install in the reverse order

AIR SUSPENSION