Remove/install cable - AR77.20-P-1400TX
MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof
Shown on left cable
| Remove/Install | |||
| 1 | Remove tilting/sliding roof panel | AR77.20-P-1000TX | |
| 2 | Remove overhead control panel control unit | AR82.20-P-1000TX | |
| 3 | Remove tilting/sliding roof motor | AR77.20-P-3010TX | |
| 4 | Unclip water drain channel (2) from left and right bracket with long wedge (3) and remove | Fig 2 | |
| 5 | Unscrew bolt (4) from cable (1) on pop-up bracket (5) | ||
| 6 | Slide pop-up bracket (5) approx. 6 cm toward rear | ||
| 7 | Unscrew bolts (7) from cover (6) and remove cover (6) upward | ||
| 8 | Slide cable approx. 10 cm toward rear | ||
| 9 | Remove cable (1) from slide rail and pull out toward rear | ||
| 10 | Install in the reverse order |