Removing and installing intake manifold - AR09.20-P-1310GS
ENGINE 111.958 /983
| Removing, installing | |||
| 1 | Disconnect ground cable of battery | AR54.10-P-0003A | |
| 2 | Remove trim panel (1) of intake manifold | ||
| Risk of explosion from ignition, risk of poisoning from inhaling and swallowing fuel, as well as risk of injury from skin and eye contact with fuel. | No fire, sparks, naked flames or smoking. Pour fuels only into suitable and appropriately marked containers. Wear protective clothing when handling fuel. |
AS47.00-Z-0001-01A | |
| 3 | Remove fuel rail together with injectors | AR07.03-P-1450GS | |
| 4 | Remove electronic accelerator actuator | AR30.20-P-1262GS | |
| 5 | Unbolt bracket of secondary air injection switchover valve (Y32) at intake manifold | ||
| 6 | Disconnect socket at pressure sensor (B18) and at altitude correction sensor (B28) | ||
| 7 | Disconnect socket of O 2 sensor upstream of catalytic converter, oil level indicator sensor and AC compressor | ||
| 8 | Unclip engine wiring harness at fixture of intake manifold | ||
| 9 | Disconnect vacuum line (a, b) at intake manifold | ||
| 10 | Unplug socket of crankshaft position sensor | AR15.12-P-2133GS | |
| 11 | Unplug socket of knock sensor | AR15.12-P-2183GS | |
| 12 | Disconnect circuit 50 at starter | ||
| 13 | Unscrew bolts (19/1) and take off intake manifold (19) | *BA09.20-P-1001-01B | |
| 14 | Install in the reverse order | ||
| 15 | Check idle speed, set | ||
| 16 | Read fault memory, erase | Stored faults which can result from cables being disconnected or from simulation during removal and installation or test work, have to be processed and erased in the fault memories after completing the work. Refer to: ↓ |
| Number | Designation | Engine 111 | |
|---|---|---|---|
| BA09.20-P-1001-01B | Bolts and nuts of intake manifold to cylinder head | Nm | 20 |