Remove/install headlamp unit - AR82.10-P-4730GR

MODEL 463.243 /244 /245 /246 /247 /248 /249 /250 /254 /270 /271 /309 /322 /323 /332 /333 

Shown on right-hand side 

Fig 1: Removing/Installing Headlamp Unit

Courtesy of MERCEDES-BENZ USA

	Remove/install
1	Remove headlamp trim		AR88.00-P-2100GR
2	Remove headlamp unit (E2, E1)	For this purpose, undo screws (1) from headlamp unit (E2, E1).
3	Detach electrical connector (2) for low beam and high beam
4	Detach electrical connector (3) for standing lamp
5.1	Completely unscrew adjustment screw (4) from headlamp range control (5)	Except model 463.246/249/271 Do not damage hydraulic line for headlamp range adjustment nor dismantle it, as otherwise the complete headlamp range adjustment assembly will have to be replaced.
6.1	Turn headlamp range adjustment (5) to left and remove from headlamp bracket (6)	Except model 463.246/249/271 Do not damage hydraulic line for headlamp range adjustment nor dismantle it, as otherwise the complete headlamp range adjustment assembly will have to be replaced. In the event of defective headlamp range adjustment: ↓ Replace headlamp range control.	AR82.10-P-4000GR
7	Install in the reverse order
8	Check and correct headlamp setting
			AP82.10-P-8260G