Remove/install windshield washer hose - AR82.35-P-6980Q

MODEL 209 except CODE (P98) Black Series 

Fig 1: Identifying Windshield Washer Hose Components - Shown On Model 209.3

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.

Shown on model 209.3 

	Remove/install
1	Open engine hood		AR88.40-P-1000Q
2	Remove fender liner in left front fender	Front and center fender liner.	AR88.10-P-1300P
3	Disconnect washer nozzle hose heater connector (X88/7)	For vehicles with code 875 Heated windshield washer system
4	Detach washer fluid hose (2) and seal	Carefully detach washer fluid hose (2) in order to avoid any damage. Collect any escaping window washer fluid in a suitable container.
			Fig 2
5	Remove air intake grille on engine hood		AR88.40-P-3001Q
6	Press T-piece (4) out of left windshield washer nozzle (7)	Carefully press out T-piece (4) from left windshield washer nozzle (7) to avoid any damage.
7	Push angle piece (6) out of right windshield washer nozzle (5)	Carefully push out angle piece (6) from right windshield washer nozzle (5) to avoid any damage.
8	Expose washer fluid hose (2) and remove	Open cable duct (3).
9	Install in the reverse order
10	Carry out function check
11	Check windshield washer system fluid level and correct if necessary
	Check windshield washer system fluid level and correct if necessary		AP82.35-P-8210P

Fig 2: Identifying Set Of Stop Plugs (129 589 00 91 00)

Courtesy of MERCEDES-BENZ OF NORTH AMERICA.