Retrofitting CD changer - AZ82.64-P-0001K

MODEL 210.0 from 1.7.98 to 30.6.99 

with CODE (317) portable D-network cell phone (D2B) 

except CODE (347) TELE AID emergency call system (D2B) 

except CODE (351) auto-pilot system (APS) 

only in combination with Audio 10 or Audio 30 radio 

MODEL 210.0 as of 1.7.99 

with CODE (317) portable D-network cell phone (D2B) 

with CODE (352a) COMAND operating and display system 

with CODE (353) Audio 30 APS 

except CODE (347) TELE AID emergency call system (D2B) 

in combination with all Audio series radios (except radio 5), COMAND or Audio 30 APS (only units with TN A 208 820 ... ...) 

	Notes on the optical wave guide	Models 129, 168, 170, 202, 208, 210, 220.	AH82.70-P-0001-02A
	Removal
1	Disconnect ground cable of battery		AR54.10-P-0003A
2	Remove paneling in trunk on left
3	Remove radio
4	Lift floor covering on driver's side		AR68.20-P-2050F
5	Open left wiring duct
6	Remove rear seat and rear seat backrest		AR91.12-P-1700F
	Install
	Notes on D2B ring	Determine actual configuration on model 210.0.	AH82.70-P-0001-03A
7	Install optical wave guide module	For extension of optical wave guide ring.
			AR82.70-P-0004-01A
8	Expand D2B fiber optic cable wiring harness and retrofit power supply.	Do not kink or stretch D2B fiber optic.	AZ82.64-P-0001-01F
	Cover optical wave guide	Install caps on fiber optic cable connector and equipment connector	AR82.95-P-0005-01A
9	Retrofit CD changer in trunk		AZ82.64-P-0001-05A
10	Reassemble vehicle 6 - 1
11	Perform startup and function check	Code CD changer to vehicle.	*WH58.30-Z-1036-13A
12	Enable radio code	Only when installing new radio