Remove/install antenna for global positioning system (GPS) on vehicles with APS - AR82.61-P-7474P

MODEL 203, 209.3 with CODE (352) COMAND operating and display system with CODE (353) Audio 30 APS with CODE (525) MB Audio 50 APS radio with CODE (527) COMAND APS (with navigation) with CODE (529) HIGH Class Japan with CODE (530) COMAND APS USA (with navigation system) 

Illustrated on model 203.0 

Fig 1: Identifying Antenna For (GPS) On Vehicles With APS Remove/Install Components - Illustrated On Model 203.0

	Remove/install
	Information on preventing damage to electronic components due to electrostatic discharge		AH54.00-P-0001-01A
1.1	Release headliner and place down at front, see: ↓
	Remove/install headliner	Model 203.0	AR68.30-P-4300P
	Remove/install headliner	Model 209.3	AR68.30-P-4300Q
1.2	Remove tailgate window	MODEL 203.2	AR67.20-P-3550PA
1.3	Remove trunk lid	MODEL 203.7	AR67.20-P-2000PB
2	Remove GPS antenna connector (A2/23) from bracket on right C-pillar
3	Disconnect connector (3)
4	Unclip right wirings (1) and remove line (2)
5	Release GPS antenna (A2/23) from rear window	Carefully heat repair area using hot air gun. Installation:  When gluing on the GPS antenna (A2/23), make sure that after removing the protective foil on the adhesive pad, it is stuck to the rear window immediately. Once positioned, apply pressure to the GPS antenna (A2/23) for approx. 5 s.
			Figure
			*WH58.30-Z-1004-20A
6	Remove adhesive residues from rear window	Use activator.	*BR00.45-Z-1023-04A
		Apply bonding agent to bonding surface on rear window.	*BR00.45-Z-1019-02A
7	Install in the reverse order

Special tools 

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)