Removing and installing instrument panel - AR68.10-P-1000GH

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175 

Fig 1: Identifying Instrument Panel Components

	Remove/install
1	Remove instrument panel bottom section (10)		AR68.10-P-1040GH
2	Remove A-pillar trim on left and right		AR68.30-P-4050GH
3	Remove upper section of air outlet panel (1)	Long wedge	Figure
4	Unscrew screws (3) from upper side of instrument panel
5	Remove instrument cluster (A1 remove		AR54.30-P-6015GH
6.1	Disconnect sun sensor connector	Only as of 01.09.01: Connector is located behind instrument cluster
7.1	Remove Parktronic display	Only with Parktronic system (PTS), Code 220a.	AR54.65-P-0003GH
8.1	Disconnect connector from actuator motor for air distribution flap	Only as of 01.09.01: Connector is located at center air outlet nozzle on driver's side.
9.1	Disconnect connector from temperature sensor	Only as of 01.09.01: Connector is located on right side of center air outlet nozzle.
10	Remove screws (9) from center of instrument panel
11	Remove screws (4) from sides of instrument panel
12	Remove instrument panel (2)	Danger of damaging instrument panel when removing and installing
13	Install in the reverse order

Fig 2: Identifying Long Wedge (115 589 03 59 00)