Adaptive damping system (ADS II) diagnosis fault memory - AD32.32-P-4000B
MODEL 140 as of 1.6.94, 210 with CODE (216b) adaptive damping system (ADS) with level control
| Adaptive damping system (ADS II) diagnosis, previous knowledge | AD32.32-P-2000B | ||
| Connect Hand-Held Tester (HHT) and read out fault memory | AD00.00-P-2000-03A | ||
| Read out fault memory for ADS control module, suspension (N51) and, on model 140 with module box, fault memory of the base module (BM) (N16/1). | AD32.32-P-6000A AD32.32-P-7004A AD32.32-P-7006A Carry out in full |
||
| If no fault is stored in the event of a complaint: | |||
| Fault memory | |||
| Fault code |
Possible cause | Notes | Remedy |
| 002 | ADS control module (N51), suspension | N51 | |
| 003 | Left front body lateral acceleration sensor (B24/3) | AD32.32-P-6000-16A | |
| 004 | Right front body lateral acceleration sensor (B24/4) | AD32.32-P-6000-16B | |
| 005 | Right rear body lateral acceleration sensor (B24/6) | AD32.32-P-6000-16C | |
| 006 | Front axle solenoid valve 1 (Y51y1), left | AD32.32-P-6000-07B | |
| 007 | Front axle solenoid valve 2 (Y51y2), left | AD32.32-P-6000-07B | |
| 008 | Front axle solenoid valve 1 (Y52y1), right | AD32.32-P-6000-08B | |
| 009 | Front axle solenoid valve 2 (Y52y2), right | AD32.32-P-6000-08B | |
| 010 | Rear axle solenoid valve 1 (Y53y1), left | AD32.32-P-6000-09B | |
| 011 | Rear axle solenoid valve 2 (Y53y2), left | AD32.32-P-6000-09B | |
| 012 | Rear axle solenoid valve 1 (Y54y1), right | AD32.32-P-6000-10B | |
| 013 | Rear axle solenoid valve 2 (Y54y2), right | AD32.32-P-6000-10B | |
| 014 | ADS MIL (A1e27), suspension | AD32.32-P-6000-03B | |
| 015 | Steering angle sensor (N49) | AD32.32-P-6000-05B | |
| 016 | Steering angle sensor (N49), incorrect signal | AD32.32-P-6000-05B | |
| 017 | Steering angle sensor (N49) not initialized | AD32.32-P-6000-06B | |
| 018 | Model 140:
Front right wheel speed signal from ASR, ETS (N47-1, N47-2) or ESP (N47-5) control module Model 210: Front left wheel speed signal from ASR (N47/1) or ETS (N47/2) control module |
AD32.32-P-6000-14A | |
| 019 | Comfort/sport switch (ADS) (S45/1) | AD32.32-P-6000-17A | |
| 020 | Battery voltage too low | AD32.32-P-6000-01B | |
| 021 | Battery voltage too high | AD32.32-P-6000-01B | |
| 022 | Stop lamp switch (4-pin) (S9/1) | AD32.32-P-6000-15A |