Retrofit combined CTEL and radio antenna - AN82.62-P-0001B
MODEL 210.2 with CODE (450) Taxi version
The antenna is installed together with an antenna splitter. As a result, telephone and two-way radio reception is possible with one antenna.
The antenna has a two-way radio frequency range of 144 to 174 MHZ.
| Removal | |||
| 1 | Disconnect ground lead from battery | AR54.10-P-0003A | |
| 2 | Remove radio | AR82.60-P-7502EA | |
| 3 | Remove two-way radio | ||
| 4 | Remove center console | AR68.20-P-2000F | |
| 5 | Remove right front seat | AR91.10-P-1000F | |
| 6 | Remove door sill moldings from right front and rear door | ||
| 7 | Remove right footwell outlet | ||
| 8 | Remove rear air duct in right footwell | ||
| 9 | Remove lower right B-pillar paneling | ||
| 10 | Remove center and right roof frame paneling | AR68.30-P-4470A | |
| 11 | Detach left roof frame paneling | ||
| 12 | Loosen or remove side trim panel in right rear | AR68.30-P-4780B | |
| 13 | Open cable duct cover in footwell and on right front and rear door entrance | ||
| 14 | Remove soundproofing in right rear | ||
| 15 | Remove trim on right C-pillar | AR68.30-P-4490FA | |
| 16 | Remove right rear belt end fitting | ||
| Install | |||
| 17 | Make an antenna fastening hole | AN82.62-P-0001-01B | |
| 18 | Retrofit antenna | AN82.62-P-0001-02B | |
| *BA82.62-P-1001-01A | |||
| 19 | Retrofit antenna line and antenna splitter | AN82.62-P-0001-03B | |
| 20 | Install in the reverse order | ||
| 21 | Carry out function check |
| Number | Designation | Model 210.2 | |
|---|---|---|---|
| BA82.62-P-1001-01A | Bolt/nut of antenna base to vehicle roof | Nm | 3 |
The parts required for installation can be found in the following replacement part documentation:
Parts ordering notes
| RP microfiche, group or special equipment | Designation | Quantity |
|---|---|---|
| SA 57.541 | Microphone, wiring harnesses, switch | 1 |