Retrofitting antenna cable and antenna splitter - AN82.62-P-0001-03B
- Route two-way radio roof antenna wiring harness (1) from two-way equipment shaft in trunk according to drawing, if applicable connect to two-way radio according to manufacturer's instructions and fasten to present wiring harnesses with cable straps.
- Screw antenna splitter (A28/1) onto bracket.
2 sheet metal screws.
- Connect two-way radio roof antenna wiring harness (1) to antenna splitter (A28/1).
- Install antenna splitter lead (2) and connect to antenna (A28).
- Fasten lead to present wiring harnesses with cable straps.