Retrofit combined CTEL and radio antenna - AN82.62-P-0001A
MODEL 210.0 with CODE (450) Taxi version
The antenna is installed together with an antenna splitter. As a result, telephone and two-way radio reception is possible with one antenna.
The antenna has a two-way radio frequency range of 144 to 174 MHZ.
| Removal | |||
| 1 | Disconnect ground lead from battery | AR54.10-P-0003A | |
| 2 | Remove radio | AR82.60-P-7502EA | |
| 3 | Remove two-way-radio | ||
| 4 | Remove center console | AR68.20-P-2000F | |
| 5 | Remove left front seat | AR91.10-P-1000F | |
| 6 | Remove door sill moldings from left front and rear door | ||
| 7 | Remove rear seat and rear seat backrest | AR91.12-P-1700F | |
| 8 | Remove left footwell outlet | ||
| 9 | Remove rear air duct in left footwell | ||
| 10 | Remove lower left B-pillar paneling | ||
| 11 | Remove headliner | AR68.30-P-4300F | |
| 12 | Remove left luggage compartment lining | ||
| 13 | Open cable duct cover in footwell and on left front and rear door entrance | ||
| Install | |||
| 14 | Make an antenna fastening hole | AN82.62-P-0001-01A | |
| 15 | Retrofit antenna | AN82.62-P-0001-02A | |
| *BA82.62-P-1001-01A | |||
| 16 | Retrofit antenna line and antenna splitter | AN82.62-P-0001-03A | |
| 17 | Install in the reverse order | ||
| 18 | Carry out function check |
| Number | Designation | Model 210.0 | |
|---|---|---|---|
| BA82.62-P-1001-01A | Bolt/nut of antenna base to vehicle roof | Nm | 3 |
The parts required for installation can be found in the following replacement part documentation:
Parts ordering notes
| RP microfiche, group or special equipment | Designation | Quantity |
|---|---|---|
| SA 57.541 | Microphone, wiring harnesses, switch | 1 |