Convenience closing of power windows function - GF72.29-P-3005KA

MODELS 208.435 /444 /445 /447 /448 /465 /470 

Function prerequisites 

• No overvoltage/undervoltage
• circuit 15 off and
• circuit 15R off and
• circuit 15c off detected

Convenience closing of the vehicle is performed with the aid of the transmitter key (infrared remote control) or at the lock switches. All side windows are moved down together for the convenience opening function.

Convenience closing of the front power windows 

The door control module (N69/1) or (N69/2)  receives over CAN the request for convenience closing and then actuates the power window motor (M10/3) or (M10/4)  . The motor is at most actuated until the door control module detects through position recognition  that the window is closed. When operating using the transmitter key or lock switch  ( , ) the convenience closing function of the power window is also performed for non-normalized windows.

Convenience closing of the rear power windows 

The roll bar (RB)/soft-top operation control module (N52)  receives over CAN the request for convenience closing and then directly actuates the power window motors (M10/5)  and (M10/6)  . The motors are at most actuated until N52 detects through position recognition  that the window is completely open.

Interruption of convenience closing function 

The convenience closing function is aborted if

• the request over CAN is no longer received or
• lock-up of the power window is detected or
• the function requirements listed above are no longer satisfied.

	Position recognition for power windows		GF72.29-P-4000KA
	Lock up recognition for power windows		GF72.29-P-4001KA
	Synchronization of power windows	Only with front power windows	GF72.29-P-4003A
	Convenience opening of the power windows		GF72.29-P-3004KA
	Convenience actuation using transmitter key		GF80.45-P-2003KA
	Convenience actuation using lock switch		GF80.45-P-2004KA