Close tilting/sliding roof function - GF77.20-P-2002A

MODELS 202 as of 1.6.97, 208, 210.081 /281 (except 208.4), 210 (except 210.081 /281) as of 1.3.97 

Function prerequisites 

• no overvoltage/undervoltage

Function 

The close tilting/sliding roof function is only available in the normalized state  of the tilting/sliding roof. It is triggered by pulling the tilting/sliding roof switch (N70s1) downward.

The overhead control panel control module (N70)  then actuates the

motor of the tilting/sliding roof (M12/1)  . The direction in which the motor is actuated depends on whether the sliding roof or the tilting roof is open. The motor is actuated until the overhead control panel control module (N70)  through the position measurement  detects that the tilting/sliding roof is closed, or lock-up  of the tilting/sliding roof is detected.

	Opening pop-up roof, function		GF77.20-P-2003A
	Open sliding roof function		GF77.20-P-2004A
	Sliding/pop-up roof lock-up recognition, function		GF77.20-P-3000A
	Tilting/sliding roof (SR) position measurement, function		GF77.20-P-3001A
	Tilting/sliding roof (SR) normalization, function		GF77.20-P-3002A
	Tilting/sliding roof motor		GF77.20-P-4100A
	Overhead control panel control module		GF82.20-P-4101A