Remove/install tilting/sliding roof frame - AR77.20-P-3000P

MODEL 203.0 /2 with CODE (414) Power glass tilting/sliding roof 

Fig 1: Identifying Tilting/Sliding Roof Frame Remove/Install Components

Shown on model 203.0 

Fig 2: Identifying Bolts And Assembly Pliers

	Remove/Install
1.1	Remove paneling from tilting/sliding roof	Only when replacing tilting/sliding roof frame	AR77.20-P-0500P
2.1	Remove tilting/sliding roof cover	Only when replacing tilting/sliding roof frame	AR77.20-P-1000P
3	Loosen headliner and lay down in vehicle with electric wiring harnesses connected.	Do not remove center console and electrical detachable body components in headliner, do not expose wiring harnesses, see↓ Remove/install headliner
		Model 203.0	AR68.30-P-4300P
		Model 203.2	AR68.30-P-4300PA
4	Remove water drain hoses (1)	Installation:  Do not kink water drain hoses (1), otherwise water drain hoses (1) can be damaged.
5	Insert assembly pliers (5) on both sides		Fig 3
6	Unscrew screws (2, 3)	Note installation position of bolts (2, 3).
			*BA77.20-P-1003-01A
7	Remove assembly pliers (5) and remove tilting/sliding roof frame from vehicle	Helper required
			Fig 3
8.1	Install seal (4) on new tilting/sliding roof frame	Only when replacing tilting/sliding roof frame
9	Install in the reverse order
10	Perform teach-in procedure for sliding roof obstruction sensor
	Connect STAR DIAGNOSIS and read out fault memory		AD00.00-P-2000-04A
		STAR DIAGNOSIS diagnosis system	*WH58.30-Z-1048-13A

SLIDING ROOF-ELECTRICS

Fig 3: Identifying Assembly Pliers (202 589 01 37 00)