Retrofitting illuminated door sill molding - AZ82.20-P-0001B

MODEL 163.113 /128 /136 /154 /172 /174 /175 

Fig 1: Identifying Retrofitting Illuminated Door Sill Molding Components

It is also possible to order the illuminated door sill molding with the lettering "AMG" - see parts ordering notes.

	Removal
	Contact with components under high voltage can pose lethal hazard	Do not touch parts which conduct high voltages. Persons who wear electronic implants (e.g. heart pacemakers) must not carry out any work on such components.	AS00.00-Z-0020-01A
1	Connect quiescent current retention unit		*WH58.30-Z-1012-09A
2	Disconnect ground cable of battery
			AR54.10-P-0003A
3	Open fuse and relay module (F1)	2 covers. Rear cover is attached with 5 screws.
4	Remove screws for fuse block	2 screws at front.
5	Remove door sill moldings on right and left driver side	Up to VIN A145272, X708318: Begin in the middle in order to avoid damaging the retaining clips. As of VINA145273, X708319: Begin at the front in order to avoid damaging the retaining clips.
			Figure
6	Take out the two frontmost screws of the door sill molding at the right and left driver side
7	Pull off door rubber seal at bottom of right and left driver door
8	Remove cover below left of instrument panel
			AR68.10-P-1500GH
9	Remove cover below instrument panel on right
		Up to VIN A145272, X708318	AR68.10-P-1520GH
		As of VIN A145273, X708319	AR68.10-P-1520GI
10	Remove right and left paneling in footwell
			AR68.30-P-4010GH
	Install
11	Install wiring harness for illuminated door sill molding and connect		AZ82.20-P-0001-02B
12	Insert the front screws of the right and left door sill molding trim
13	Stick luminous foil onto rear of illuminated door sill molding	The silver side of the luminous foil is the underside. Pull off protective foil of the double-sided adhesive tape on the rear of the door sill molding and stick on luminous foil.
14	Connect illuminated door sill molding to coupling (5) of wiring harness (1)
15	Clip illuminated door sill moldings into door sill trim	Ensure that the door sill moldings are not installed on the wrong sides and that the wiring harness is not pinched by the door sill molding.
16	Stick rear door sill moldings onto standard moldings	Only in the case of 4-part "AMG" parts kit.
17	Carry out operational check
18	Assemble in reverse order

Fig 2: Identifying Longitudinal Wedge (115 589 03 59 00)