Preparations for dimensional and comparative measurement - AR40.30-P-0401A

MODEL 129, 140 

Fig 1: Identifying Preparations For Dimensional And Comparative Measurement - Model 129, 140 (1 Of 3)

Fig 2: Identifying Preparations For Dimensional And Comparative Measurement - Model 129, 140 (2 Of 3)

Fig 3: Identifying Preparations For Dimensional And Comparative Measurement - Model 129, 140 (3 Of 3)

	Checking
1	Align vehicle horizontal in the longitudinal direction by loading with suitable weights	Measurement of inclination via door entrance edges, e.g. carry out with a spirit level.
2.1	On vehicles with cross traverse (63a), remove and install this
3	Screw in threaded bolts (07n)	Install threaded bolts in the rearmost tapped holes "k" in fixing rail (64). Depending on the model, Remove cross traverse (63a) or unscrew rear bolts from engine suspension (63) or remove plugs for tapped holes.
4	Insert suspension (07) horizontal and adjust supports (07r, 07s)	Adjust according to the respective model	AR40.30-P-0401-01A
			Figure
5	Install telescopic measuring rod (06) with connecting parts on retaining pin (024b)	Insert respective measuring tips/pins (024) for the corresponding distance or comparative measurement
		Connecting parts	Fig 8
		Telescopic measuring rod	Fig 5
		Telescopic measuring rod	Fig 6
		Measuring fixture set	Fig 7
6	Carry out distance and comparative measurement at front and rear axle	Model 129	AR40.30-P-0402A
		Model 140	AR40.30-P-0402B

Fig 4: Identifying Mount (170 589 00 63 00)

Fig 5: Identifying Telescopic Measuring Rod (124 589 01 19 00)

Fig 6: Identifying Telescopic Measuring Rod (124 589 02 19 00)

Fig 7: Identifying Measuring Fixture Set (140 589 09 63 00)

Fig 8: Identifying Connecting Parts (124 589 08 63 00)