Suspension -- 208 Chassis
- General Information
- Testing & Repair
- Testing and repair work: Passenger cars: Suspension - AR32.00-Z-9208AA
- Removing and installing front spring - AR32.20-P-0200B
- Removing and installing rear spring - AR32.20-P-0230A
- Removing and installing torsion bar on front axle - AR32.20-P-0300C
- Removing and installing torsion bar on rear axle - AR32.20-P-0315C
- Removing and installing front shock absorber - AR32.25-P-0105A
- Remove/install rear shock absorber - AR32.25-P-0110A
- Checking shock absorber - AR32.25-P-0121A
- Rear strut removal and installation - AR32.25-P-1016A
- Checking hydraulic pump - AR32.30-P-0510A
- Rear suspension-control module - Operation check - AR32.30-P-0520A
- Testing pressure at rear axle level controller - AR32.30-P-0530A
- Check, adjust gap between strut and wheel-housing - AR32.30-P-0610-01A
- Rear hydraulic suspension pressure accumulator, removal and installation - AR32.30-P-0620A
- Emptying and filling pressure oil system - AR32.30-P-0630A
- Rear suspension-control module, removal and installation - AR32.30-P-0670A
- Maintenance
- Miscellaneous Notes
- Disposing of damper strut: Risk of injury from drilling gas-filled subassemblies or components (gas filling cannot ignite) - OS32.25-P-0120-01A
- Disposing of shock absorber: Risk of injury from drilling gas-filled units or components (gas fill is not inflammable) - OS32.25-P-0121-01A
- Disposing on spring actuator - OS32.30-P-0620-01A