Power windows with one-touch window up and window down control, function - GF72.29-P-3007A

MODEL 202 as of 1.6.97 

MODELS 208, 210.081 /281 (except 208.4) 

MODEL 210 (except 210.081 /281) as of 1.3.97 

Function prerequisites 

• No overvoltage/undervoltage
• Circuit 15 on or circuit 15R on

Function 

The automatic window raising/lowering function is triggered by pressing the power window switch over the first click-stop position in the "open" or "close" direction. The corresponding door control module  receives a CAN message and actuates the relevant power window  until the window is completely closed or opened, even if the switch has already been released.

With non-normalized  windows, instead of the automatic window raising/lowering function, the manual window raising/lowering  function is performed.

In the , , and versions of MODEL 208, instead of the automatic window raising function, the manual window raising  function is performed.

Function abort 

The window raising/lowering function is aborted if

• the power window switch is pressed again, after it was in the center position,
• lock-up of the power window is detected,
• the function prerequisites are no longer satisfied,
• with window raising, the obstruction sensor  reacts,
• with window lowering, denormalization  takes place.

	Position recognition for power windows		GF72.29-P-4000A
	Manual window up/down control		GF72.29-P-3006A
	Synchronization of power windows		GF72.29-P-4003A
	Anti-pinch protection		GF72.29-P-4004A
	Power windows in front doors		GF72.29-P-4101A
	Rear door control module	MODELS 202/210 only	GF72.29-P-4102A
	Driver-side front door control module		GF72.29-P-4105A
	Passenger-side front door control module		GF72.29-P-4106A