Function of hazard warning flashers - GF82.25-P-2004A

MODEL 202 as of 1.6.97, 208, 210.081 /281, 210 as of 1.3.97 

Function 

The hazard flasher switch (S6/1s1)  is connected to the driver-side signal acquisition and actuation module (SAM) (N10/1)  via a discrete line. When the hazard flasher switch (S6/1s1) is actuated, the corresponding input on the driver-side signal acquisition and actuation module (SAM) (N10/1)  is connected to ground through the switch. The driver-side signal acquisition and actuation module (SAM) (N10/1)  then actuates all turn signal lamps at a frequency of approx. 1.5 Hz. In addition the LED's for the hazard

flasher indicator in the hazard flasher switch (S6/1s1) and the turn signal indicator lamps in the instrument cluster (A1) as well as the audible turn signal indicator are actuated by the driver-side signal acquisition and actuation module (SAM) (N10/1) via discrete lines.

Hazard flashing is possible  with the ignition/starter switch in any position.

Bulb failure is not  recognized during the hazard flasher function!

	Location of turn signal/hazard warning flasher components	GF82.25-P-0002-01A
	Interlinkage of turn signal/hazard warning flasher components	GF82.25-P-0002-02A
	Driver-side signal acquisition and actuation module (SAM) (N10/1)	GF54.00-P-4101A