Remove and install front door crank window - AR72.10-P-1900E

MODEL 202, 210 

Front door 

Shown on model 202 

Fig 1: Identifying Crank Window - Shown On Model 202

Fig 2: Identifying Front Door Crank Window Components - Model 202, 210

Modification notes

10.4.95

Grease sliding jaws

Step no. 7

	Remove/install
1	Remove window crank	Model 202 Window open	AR72.10-P-1100GV
2	Remove door liner on front door	Model 202	AR72.10-P-1000E
		Model 210	AR72.10-P-1000F
3	Remove foil on inner door panel in lower area	Before removing foil check crank window for easy motion.
4	Remove inner sealing rail		AR72.10-P-1600E
5	Remove trim strip with outer sealing rail		AR72.10-P-1700E
6	Unscrew bolt (2)	For removal open crank window until screw (2) in assembly opening is accessible. Installation:  When installing screw (2): ↓
		Adjust front door crank window	AR72.10-P-1950E
7	Pull crank window (1) downward at front out of front window guide rail, move upward on outside past window guide rail and simultaneously out of sliding jaws (5 and 6).	When installing grease sliding jaws and guide rail with multi-purpose grease	*BR00.45-Z-1009-06A
8	Remove crank window upward out of door shaft, install	Tilt window forward
9	Install in the reverse order

Repair materials

Number	Designation	Order number
BR00.45-Z-1009-06A	Multi-purpose paste	A 000 989 80 51 10