Removal and installation of rear door window frame molding - ra72001400370x(0370)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Model 140
Preliminary work:
Removal and installation of the outer sealing bar .
Removal and installation of the rear door surround .
Removal and installation of the lining on the rear door .
| Window runner | remove. |
| Lining on inner window stay | remove (Adjustment of the crank window in the rear door ). |
| Vapor seal (4) | partially detach from inner door panel (Fig 1) |
| Screw (1) | unscrew from upper window stay (Fig 1) while pulling out door sealing frame in the area of the stay. |
| Screw (2, 3 pieces) | unscrew from window stay (Fig 1) |
| Screw (3) | detach from lower window stay (Fig 1). |
| Window stay (1) | pull forward (Fig 2). |
| Stationary window (2) together with rubber frame and surround (Fig 2) | pull forward approx. 1 - 2 cm. |
| Molding (1) | remove with caulking tool (Fig 3). Use special tool 116 589 07 59 00. |
| Molding (1, Fig 4) | install, whilst starting at the top front using caulking tool. Align molding flush with window frame and surround. |
| Reinstall in opposite order. |
Special tools