Remove brake of overdrive (BS) and clutch (KS), install - AR27.50-P-0740A: Notes
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
TRANSMISSION 722.5
| Removing | |||
| 1 | Remove rear transmission cover | AR27.30-P-0680A | |
| 2 | Take off output shaft (86); remove circlip (165) for this step | ||
| 3 | Remove internal geared wheel (170) | AR27.50-P-0740-01A | |
| 4 | Take out clutch KS (172) together with set of plates | ||
| Disassemble clutch KS, assemble and measure | AR27.51-P-0760A | ||
| 5 | Take set of plates BS out of housing; remove circlip (176) for this step | ||
| 6 | Remove piston BS (192) | AR27.50-P-0740-02A | |
| Installing | |||
| 7 | Install piston BS (192) and plates for brake BS | AR27.50-P-0740-03A | |
| 8 | Install internal geared wheel (170), sun gear (171) and planet carrier (168) | AR27.50-P-0740-04A | |
| Measuring | |||
| 9 | Measure axial play of output shaft - intermediate shaft | AR27.50-P-0740-05A | |
| Figure | |||
| 10 | Measure axial play of output shaft - rear cover | AR27.50-P-0740-06A | |
| Figure | |||
| 11 | Measurement of play in multi-discs for overdrive brake | AR27.50-P-0740-07A | |
| Figure | |||
| 12 | Install rear transmission cover | AR27.30-P-0680A |
MULTI-DISK CLUTCH
| Number | Designation | Transmission 722.5 | |
|---|---|---|---|
| BE27.50-P-1001-01A | Axial play between output shaft and intermediate shaft | mm | 0.1 |
| BE27.50-P-1002-01A | Axial play between output shaft and rear cover | mm | 0.4 |
INSPECTION DATA OF BRAKE BAND/MULTI-PLATE BRAKE
| Number | Designation | Transmission 722.5 | |
|---|---|---|---|
| BE27.50-P-1001-02A | Clearance of multi-plate brake BS | mm | 0.5-1.1 |