Removing and installing blower motor - ra83001400876x(0876)
WARNING: This page does not describe the selected car, but rather 42 other vehicles, including the 1999 Mercedes-Benz S600, 1999 Mercedes-Benz S500, 1999 Mercedes-Benz S420, 1999 Mercedes-Benz S320, and 1999 Mercedes-Benz CL600. However, it is still accessible from the selected car via links, so may be relevant.
Model 140
| Pressure in cooling system | Release, by turning the radiator cap up to detent "1" and close again. |
| Coolant | Drain, by removing front right panelling (beneath the circulation unit for rear air conditioner) (6 screws). Close supply and return hoses, blow out residual coolant from the heat exchanger with compressed air. |
| Control unit for rear air conditioner | Remove (Control unit for rear air conditioner ). |
| Center console | Remove (REMOVAL AND INSTALLATION OF THE CENTER CONSOLE ). |
| Supply and return lines (c and d) | Remove from heat exchanger (screws 23). |
| Plug connections on the heat exchanger temperature sensors B10/9 and B10/10 | Pull off. |
| Electrical harness in area of rear air conditioner | Expose. |
| Blower housing | Remove (6 clips). |
| Blower controller (N29/2) | Remove (1 screw). |
| Blower housing | Dismantle (4 clips). |
| Blower | Remove (1 screw - internal hexagon 3). |
| Install | In reverse sequence, perform function check before installing center console. |