Remove Fuel Tank Pressure Sensor: Notes

WARNING: This page is about a different variant/trim than selected.

Remove in the order indicated in the table.

Step 1

Fig 1: Evaporative Isolation Valve Hose, Evaporative Hose No. 1, Canister Ventilation Valve Component, Wiring Harness Clip, Connector, Bolts And Nuts With Torque Specification

Courtesy of MAZDA MOTORS CORP.

TIGHTENING TORQUE SPECIFICATION

Step	Part name
1	Evaporative isolation valve hose (See Evaporative isolation valve hose connection note )	-
2	Evaporative hose No. 1	-
3	Nut (See Nut and bolt installation note )	11 N.m {110 kgf cm, 95 in.lb}
4	Bolt (See Nut and bolt installation note )	11 N.m {110 kgf.cm, 95 in.lb}
5	Connector	-
6	Wiring harness clip	-
7	Canister ventilation valve component	-

Step 2

Courtesy of MAZDA MOTORS CORP.

PART NAME DESCRIPTION

Step	Part name
1	Hose clip	-
2	Quick release connector (emission system) No. 5 (See Quick release connector (emission system) No. 5 disconnection note ) (See Quick release connector (emission system) No. 5 connection note )	Engine oil
3	Fuel tank pressure sensor	-