Remove Fuel Injectors: Notes
WARNING: This page is about a different variant/trim than selected.
WARNING:
- Always keep sparks and flames away from fuel. Fuel can easily ignite which could cause serious injury or death, and damage to equipment.
- Highly pressurized fuel may spray out if the fuel line is cut. Due to the following dangers occurring with a fuel spray, always complete the [Fuel Line Safety Procedure] to prevent the fuel from spraying.
- Fuel may cause irritation if it comes in contact with skin and eyes.
- If fuel ignites and causes a fire, it may lead to serious injury or death, and damage to property and facilities.
- A person charged with static electricity could cause a fire or explosion, resulting in death or serious injury. Before servicing the fuel system, make sure to discharge static electricity by touching a vehicle.
CAUTION:
- Be careful when handling the end area of the fuel injector. If the end area of the fuel injector is touched by hand or pressed against an object, it could cause a malfunction.
- Remove in the order indicated in the table.PART NAME DESCRIPTION
Step Part name 1 Fuel injector component
(See FUEL INJECTOR COMPONENT INSTALLATION NOTE )Engine oil - - 2 Spacer
(See SPACER INSTALLATION NOTE )- Replacement part - 3 Stopper ring
(See STOPPER RING REMOVAL NOTE )
(See STOPPER RING INSTALLATION NOTE )- Replacement part 49 D013 104 (component part for 49 D013 1A0) 4 O-ring Engine oil Replacement part - 5 Back-up ring
(See BACK-UP RING INSTALLATION NOTE )- Replacement part - 6 Teflon seal
(See TEFLON SEAL REMOVAL NOTE )
(See TEFLON SEAL INSTALLATION NOTE )Engine oil Replacement parts 49 D013 102, 49 D013 103, 49 D013 104 (component parts for 49 D013 1A0) 7 Fuel injector - - -