LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2024 >> CX-30 Preferred >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Automatic Transaxle (Service Information) - GW6AX-El) >> Oil Seal (Differential) Replacement [GW6AX-El] >> Transaxle Case Side

Transaxle Case Side

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
  2. Drain the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6AX-EL] .)
  3. Disconnect the front drive shaft (LH) from the transaxle. (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
  4. Remove the oil seal using a flathead screwdriver.
    G16374993Courtesy of MAZDA MOTORS CORP.
  5. Using the SSTs and a hammer, install a new oil seal.
    G16374994Courtesy of MAZDA MOTORS CORP.
    1. 0.5 mm {0.02 in}
    2. 0.8 mm {0.03 in}
  6. Apply ATF to the lip of the oil seal.
    CAUTION:
    • The oil seal is easily damaged by the sharp edges of the drive shaft splines. Do not let the splines contact the oil seal.
  7. Connect the front drive shaft (LH) to the transaxle. (See FRONT DRIVE SHAFT REMOVAL/INSTALLATION .)
  8. Add the ATF. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6AX-EL] .)
  9. Install the under cover No. 2. (See FRONT UNDER COVER No. 2 REMOVAL/INSTALLATION .)
  10. Perform the "Mechanical System Test". (See MECHANICAL SYSTEM TEST [GW6AX-EL] .)
scientia non olet · About LEMON Manuals